Tree Cutting Techniques & Tips

It is best to leave the cutting of mature trees in the hands of professionals who are properly trained and equipped. These tree-cutting tips can help you if you cannot hire a professional to do the job and must cut down the tree by yourself.

Get The Right Equipment

The correct equipment to do the job before you can learn the technique. Your equipment should be in good condition and tested before you use it to cut down a tree. This list includes the most important pieces of equipment needed to remove a mature tree from your property.

  • Chainsaw: The chainsaw is the most essential piece of equipment. The chainsaw you choose should be 3.5 horsepower with a 20-inch bar. The bar length is the measure of the depth to which the blade can go. Twenty inches should suffice for most trees.
  • Safety Eyewear: Many people forget the importance of wearing safety glasses while doing this type of work. The truth is, flying debris from a chainsaw can cause serious eye damage.
  • Leg protection: The saw may kick out from the tree if you strike a knot. You should wear either heavy leg protectors or knee-high safety boots.
  • Test Rope 1000 LB: This rope should be approximately three times as long as your tree’s height. This will serve as a backup safety in the event of an emergency.

10 Tree Cutting Techniques

Before you start, make sure that all your gear is in working order. You should invite some friends to come and help you. They will not only be there to assist in the falling of the tree but will also be available in the event that something goes wrong. If you are going to cut the tree yourself, you need to assess the risks of it falling somewhere other than on the ground. It is not a good idea to cut a tree and then have it fall onto your home, fence, or worse… the neighbor’s property. Follow these steps once you’re ready to cut your tree down safely.

  1. How tall is the tree?
  2. Decide the direction of fall based on the height and width of the tree.
  3. Remove all debris and anything that may cause damage from the area around the fall zone.
  4. The rope can be tied to the tree in the middle or just above it.
  5. Give the other end to your friends, and ask them to stand at a safe distance outside the fall zone.
  6. On the side where you want your tree to fall, cut a v shape into the tree.
  7. The notch is at about knee height, cuts to the middle of the tree, and looks like a shallow “v”.
  8. Start slowly by cutting the tree on the opposite side.
  9. As soon as the tree begins to fall, walk quickly away from it at a 45-degree angle.
  10. If your tree does not fall or is caught by another tree, ask your friends to pull the rope until it finally falls.

General Tree Cutting Tips

Hire an arborist or tree cutting in west auckland service to do the job for you. Here are some tips for those who plan to do it themselves. Here are some additional tips for tree felling and cutting.

  • Standing directly behind a tree that is falling can cause serious injury. The tree can kick back at you and cause serious injuries if the stump snaps.
  • If the tree does not fall, do not use the chainsaw to approach it. Pull it only with the rope. The tree could snap under the pressure.

Leave a Reply

Your email address will not be published. Required fields are marked *